FRONT WIPER MOTOR REMOVAL


  1. REMOVE FRONT WIPER ARM HEAD CAP


    1. A0119XCE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the 2 front wiper arm caps.

  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A0117AB

      Operate the wiper, and then stop the wiper motor in the automatic stop position.

    2. Remove the nut and front wiper arm and blade LH.

  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    1. A0118VBE01
      Text in Illustration
      *1 Double-sided Tape

      Disengage the 2 clips and 2 claws, peel off the double-sided tape, and remove the front fender to cowl side seal LH.

  5. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for LHD)


    1. A011A52

      Remove the 2 clips.

    2. Disengage the 5 claws and 9 guides, and remove the cowl top ventilator louver.

  7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD)


    1. A0117JC

      Remove the 2 clips.

    2. Disengage the 5 claws and 9 guides, and remove the cowl top ventilator louver.

  8. REMOVE COWL PANEL SUB-ASSEMBLY


    1. A01174N

      Remove the 9 bolts and remove the cowl panel.

  9. REMOVE FRONT WIPER MOTOR GROMMET


    1. A011895

      Remove the 2 front wiper motor grommets.

  10. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    1. A011BLV

      Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the 2 bolts.

    4. Slide the wiper link. Disengage the link from the rubber pin, and then disconnect the connector and remove the front wiper motor and link.

  11. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    1. A0118FEE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disconnect the right wiper rod of the windshield wiper link from the crank arm pivot of the windshield wiper motor, as shown in the illustration.

    2. A011AOIE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disconnect the left wiper rod of the windshield wiper link from the crank arm pivot of the windshield wiper motor, as shown in the illustration.

    3. A0119M6

      Using a "TORX" socket wrench T30, remove the 2 screws and the front wiper motor.