POWER WINDOW CONTROL SYSTEM Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

DESCRIPTION

If the door glass or the power window regulator motor does not operate smoothly, the jam protection function may be triggered automatically, resulting in the AUTO UP function being unable to fully close the window.

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM INITIALIZATION

   
   

   1. Initialize the power window regulator motor Click here.

   2. Check if the power window AUTO UP/DOWN function operates Click here.

      OK
      AUTO UP/DOWN function operates.

   
   

   NG

   CHECK MOVEMENT OF DOOR GLASS Click here

   OK

   END (PROBLEM DUE TO INITIALIZATION FAILURE)

2. CHECK MOVEMENT OF DOOR GLASS

   
   

   1. Remove the installation bolt of the door glass and hold the glass by hand. When raising the glass by hand, check that the glass moves smoothly.

      Note

      
      

      • Make sure that the door glass fits to the glass run properly.

      • Make sure that the glass run is not deformed, and does not have foreign matter.

        OK
        Door glass moves smoothly.

   
   

   NG

   INSTALL DOOR GLASS AND/OR GLASS RUN PROPERLY

   OK

   REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (APPLICABLE LOCATION) Click here