POWER WINDOW CONTROL SYSTEM FAIL-SAFE CHART


  1. POWER WINDOW OPERATION IN FAIL-SAFE MODE

    Tech Tips

    If the pulse sensor built into the power window regulator motor malfunctions, the power window control system enters fail-safe mode.


    1. The power window control system prohibits the following power window operation when the pulse sensor for the jam protection function has problems and the window position or the learned value is abnormal.

      Power Window Control System
      Power Window Operation Ignition Switch ON

      Key-Off

      (Within Approximately 45 Seconds after Ignition Switch Turned Off)

      Key-Off

      (After Approximately 45 Seconds Elapsed after Power Ignition Turned Off)
      MANUAL UP (Driver side door window) Operation prohibited Operation prohibited Operation prohibited
      MANUAL DOWN (Driver side door window)

      Operative

      (Jam protection not operative)

      		 Operation prohibited Operation prohibited

      AUTO UP (Driver side door window)

      (hold switch at AUTO UP position)

      Operative

      (in MANUAL mode)

      (Jam protection not operative)

      		 Operation prohibited Operation prohibited
      AUTO UP (Driver side door window) Operation prohibited Operation prohibited Operation prohibited
      AUTO DOWN (Driver side door window) Operation prohibited Operation prohibited Operation prohibited
      MANUAL UP (Remote switch operation) Operation prohibited Operation prohibited Operation prohibited
      MANUAL DOWN (Remote switch operation) Operation prohibited Operation prohibited Operation prohibited

      AUTO UP (Remote switch operation)

      (hold switch at auto up position)

      		 Operation prohibited Operation prohibited Operation prohibited
      AUTO UP (Remote switch operation) Operation prohibited Operation prohibited Operation prohibited
      AUTO DOWN (Remote switch operation) Operation prohibited Operation prohibited Operation prohibited

      Tech Tips

      When the pulse sensor is normal, the AUTO UP/DOWN function can be resumed by deactivating fail-safe mode. To deactivate fail-safe mode, pull up the power window switch to the AUTO UP position and hold it for at least 1 second to fully close the window from the fully open position.

    2. If the LIN communication line malfunctions (communication stop), the power window control system prohibits the following operations.

      Remote UP/DOWN function does not operate.

      Power Window Regulator Master Switch
      Power Window Operation Ignition Switch ON
      MANUAL UP Operative (Jam protection operative)
      MANUAL DOWN Operative (Jam protection not operative)
      AUTO UP (hold switch at AUTO UP position) Operation prohibited
      AUTO UP Operation prohibited
      AUTO DOWN Operation prohibited
      Power Window Regulator Switch
      Power Window Operation Ignition Switch ON
      MANUAL UP Operative (Jam protection operative)
      MANUAL DOWN Operative (Jam protection not operative)
      AUTO UP (hold switch at AUTO UP position) Operative (Jam protection operative)
      AUTO UP Operative (Jam protection operative)
      AUTO DOWN Operative (Jam protection not operative)