SOLAR SENSOR INSPECTION


  1. INSPECT SOLAR SENSOR (AUTOMATIC LIGHT CONTROL SENSOR)

    A011AG0E01

    1. Check the voltage.


      1. Connect the solar sensor connector.

      2. Turn the ignition switch to ON.

      3. Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Condition Specified Condition
        1(TSD) - 6(CLTE) Without direct light exposure (Sensor covered) Below 0.8 V
        1(TSD) - 6(CLTE) When exposed to sunlight or an inspection light 4.0 to 4.6 V

        Note

        Use an incandescent light for inspection. Bring it within about 30 cm (11.8 in.) of the solar sensor.