REAR BUMPER (for Wagon) REASSEMBLY

Tech Tips

When installing the rear bumper pad, heat the rear bumper cover surface using a heat light.

Standard
Item Temperature
Rear Bumper Cover 20 to 30°C (68 to 86°F)

Note

Do not heat the rear bumper cover excessively.


  1. INSTALL REFLEX REFLECTOR ASSEMBLY LH

    A003D20

    1. Attach the claw and guide to install the reflex reflector.

  2. INSTALL REFLEX REFLECTOR ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL REAR UPPER BUMPER COVER LH

    A003BDV

    1. Attach the claw to install the rear upper bumper cover.

    2. Install the screw.

  4. INSTALL REAR UPPER BUMPER COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSTALL ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

    Tech Tips

    Use the same procedure for all ultrasonic sensor retainers.


    1. A003DY2

      For the No. 1 ultrasonic sensor retainer and No. 3 ultrasonic sensor retainer:

      Attach the claw to the rear bumper cover to install the ultrasonic sensor retainer.

    2. A003DTV

      For the No. 2 ultrasonic sensor retainers:

      Attach the 2 claws to the rear bumper cover to install the ultrasonic sensor retainer.

  6. INSTALL ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)

    Tech Tips

    Use the same procedure for all ultrasonic sensor clips.


    1. A003AGH

      Attach the ultrasonic sensor clip to the ultrasonic sensor retainer from the backside of the bumper. Then attach the 2 claws of the clip to install the clip.

  7. INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

    Tech Tips

    Use the same procedure for all No. 1 ultrasonic sensors.


    1. A003DOK

      Attach the No. 1 ultrasonic sensor to the ultrasonic sensor clip from the backside of the bumper. Then attach the 2 claws of the sensor to install the sensor.

    2. A003AP1

      Connect the connector.

    3. A003EOE

      Attach the 2 clips.

  8. INSTALL NO. 2 FRAME WIRE (w/ TOYOTA Parking Assist-sensor System)


    1. Attach the 4 clamps to install the No. 2 frame wire.

    2. Connect the 4 connectors.

      A003EM5

  9. INSTALL REAR BUMPER PAD LH


    1. Clean the rear bumper cover surface.


      1. Using a heat light, heat the rear bumper cover surface.

      2. Remove the double-sided tape from the rear bumper cover.

      3. Wipe off any tape adhesive residue with cleaner.

    2. A003DLD

      Install a new rear bumper pad.


      1. Remove the peeling paper from the face of a new rear bumper pad.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      2. Install the rear bumper pad as shown in the illustration.

  10. INSTALL REAR BUMPER PAD RH

    Tech Tips

    Use the same procedure described for the LH side.