HIGH MOUNTED STOP LIGHT ASSEMBLY (for Sedan) REMOVAL

REMOVE REAR BENCH TYPE SEAT CUSHION ASSEMBLY
1. Detach the 2 front hooks of the seat cushion from the vehicle body.
  
  Note
  
  Follow the instructions below carefully as the cushion frame deforms easily.
  1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
  2. Repeat for the other hook.
2. Detach the 2 rear hooks of the seat cushion from the seatback.
  
  Note
  
  Be careful not to damage the vehicle body.
REMOVE REAR SIDE SEATBACK ASSEMBLY LH
1. Remove the bolt and disconnect the rear seat 3 point type belt anchor.
2. Using a screwdriver, detach the claw to open the cap of the rear seat shoulder belt guide.
3. Remove the seat belt from the belt guide.
4. Remove the bolt, and then remove the side seatback LH as shown in the illustration.
REMOVE REAR SIDE SEATBACK ASSEMBLY RH

Tech Tips

Use the same procedures described for the LH side.
REMOVE INNER ROOF SIDE GARNISH LH
Text in Illustration

*1 Clip A
1. Detach the 5 clips and remove the inner roof side garnish.
  
  Tech Tips
  
  The 2 clips labeled A remain attached to the body.
2. Remove the 2 clips labeled A from the vehicle body.
REMOVE INNER ROOF SIDE GARNISH RH

Tech Tips

Use the same procedure described for the LH side.
REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
1. Disconnect the connector.
2. Remove the 4 clips.
3. Detach the 2 clips and raise the front portion of the package tray trim panel assembly.
4. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
5. Detach the 5 claws and remove the package tray trim panel assembly.
REMOVE CENTER STOP LIGHT ASSEMBLY
1. Disconnect the connector.
2. Detach the 4 claws and remove the stop light.