REAR WIPER MOTOR (for Wagon) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A00ONFV

      Detach the 4 clips and remove the back door trim panel.

  4. REMOVE BACK DOOR SIDE GARNISH LH


    1. A00OHU3

      Detach the 2 clips and claw, and remove the back door side garnish.

  5. REMOVE BACK DOOR SIDE GARNISH RH


    1. A00OKRN

      Detach the 2 clips and claw, and remove the back door side garnish.

  6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    1. A00ONB5

      Detach the 14 clips and remove the back door trim board.

  7. REMOVE REAR WIPER ARM


    1. A00OKXT

      Open the wiper arm head cap.

    2. A00ON3P

      Remove the nut and rear wiper arm.

  8. REMOVE REAR WIPER MOTOR ASSEMBLY


    1. A00OM3D

      Disconnect the connector.

    2. Remove the 3 bolts and rear wiper motor assembly.

  9. REMOVE REAR WIPER MOTOR GROMMET


    1. A00OLT4

      Remove the wiper motor grommet.