OUTER REAR VIEW MIRROR REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A00OQIS

      Using moulding remover A, detach the 3 claws and remove the bezel plug.

  2. REMOVE ASSIST GRIP COVER LH


    1. A00OR1H

      Using moulding remover A, detach the 9 claws and remove the assist grip cover.

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. A00OR3FE01

      Using moulding remover A, detach the clip and 7 claws and remove the power window regulator master switch assembly with front door armrest base panel.

    2. Disconnect the connector and remove the power window regulator master switch.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    A003AIB

    1. Using moulding remover A, detach the clip and 7 claws, and remove the power window regulator master switch assembly with front door armrest base panel.

    2. Disconnect the connector.

  5. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION


    1. Remove the front door No. 1 stiffener cushion.

  6. REMOVE COURTESY LIGHT ASSEMBLY


    1. A003E87

      Detach the 2 claws and remove the courtesy light.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A00OR3U

      Remove the 3 screws.

    2. Remove the 10 clips and 2 claws.

    3. Disconnect the courtesy light connector.

    4. A00OUNGE01
      Text in Illustration
      *1 Reference Boss

      Pull out the front door trim board in the direction indicated by the arrow in the illustration to detach the 5 claws of the front inner door glass weatherstrip and remove the reference boss together with the trim board.

    5. Remove the reference boss from the front door trim board.

    6. for Power Seat:


      1. A00OR1W

        Detach the wire harness.

      2. A00OVW6

        Disconnect the connector.

      3. Disconnect the 2 cables from the inside handle.

    7. A00ORAH

      for Manual Seat:

      Disconnect the 2 cables from the inside handle.

  8. REMOVE OUTER MIRROR INSTALL HOLE COVER LH


    1. A00OUBE

      Detach the 7 claws and remove the install hole cover.

  9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    A003AX3

    1. Disconnect the connector.

    2. Detach the clamp.

    3. Remove the 3 nuts and outer rear view mirror.