BACK DOOR ADJUSTMENT


  1. INSPECT BACK DOOR PANEL SUB-ASSEMBLY


    1. Check that the clearance measurements of areas A to E are within the standard range.

      A003DYDE01
      Standard
      Area Specified Condition Area Specified Condition
      A 5.8 to 8.8 mm (0.228 to 0.347 in.) D 3.3 to 6.3 mm (0.130 to 0.248 in.)
      B 0.5 to 2.0 mm (0.0197 to 0.0787 in.) E 4.5 to 7.5 mm (0.177 to 0.295 in.)
      C 5.4 to 8.4 mm (0.213 to 0.331 in.) - -

  2. ADJUST BACK DOOR PANEL SUB-ASSEMBLY


    1. A003CJX

      Horizontally and vertically adjust the door position by loosening the door side hinge bolts.

    2. Adjust the back door by moving it up and down and left and right so that the dimensions are within the specified range.

    3. Tighten the hinge bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  3. REMOVE REAR FLOOR FINISH PLATE

    A00E6JD

    1. Detach the 4 clips and remove the rear floor finish plate.

  4. ADJUST BACK DOOR LOWER LOCK STRIKER ASSEMBLY


    1. A003EI7

      Adjust the striker position by slightly loosening the striker mounting bolts and hitting the striker with a plastic-faced hammer.

    2. Tighten the striker mounting bolts after the adjustment.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  5. INSTALL REAR FLOOR FINISH PLATE

    A00E6JD

    1. Attach the 4 clips to install the rear floor finish plate.