FRONT SEATBACK HEATER (for Manual Seat) REMOVAL

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Driver Side)


    1. A00OVI7E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 3 claws and remove the vertical seat adjuster knob cap.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)


    1. A00OT5S

      Remove the 2 screws and vertical adjusting handle LH.

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


    1. A00OSHWE01
      Text in Illustration
      *1 Protective Tape

      Raise the reclining adjuster release handle LH to reveal the claw. Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE FRONT SEAT CUSHION SHIELD LH


    1. A00OR3W

      Detach the 2 rubber bands.

    2. A00OUTV

      Remove the 2 screws.

    3. Detach the hook and claw and remove the front seat cushion shield LH.

    4. A00OV7P

      w/ Lumbar Support:

      Disconnect the connector.

  6. REMOVE FRONT SEAT INNER CUSHION SHIELD LH


    1. A00OSH0E01
      Text in Illustration
      *1 Hook
      *2 Wire Harness Clamp

      Remove the 2 screws.

    2. Detach the hook and wire harness clamp and remove the front seat inner cushion shield LH.

  7. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    1. Detach the 2 hooks.

      A00OTPF
    2. A00OU2U

      Detach the 2 hooks from the bottom of the separate type front seatback cover.

    3. A00OSE1

      Detach the 2 hooks and disconnect the 2 straps.

    4. A00OSH3

      Pass the 2 straps through the 2 holes of the separate type front seatback pad to the surface.

    5. A00OSOGE01
      Text in Illustration
      *1 Seatback Cover Bracket

      Remove the screw and detach the seatback cover bracket.

    6. A00OUE7E01
      Text in Illustration
      *1 Hook
      *2 Hog Ring

      Remove the hog rings and detach the 3 hooks from the center of the separate type front seatback pad.

    7. A00OVHM

      Detach the 7 hooks and remove the actuator shield.

    8. A00OTQXE01
      Text in Illustration
      *1 Cable End
      A00OVAR Pull

      Pull the cable to loosen it, and then disconnect the cable end from the active headrest lower unit.

    9. A00OUWJ

      Detach the 2 claws and remove the active headrest lower unit.

    10. A00OUU1

      Using a screwdriver, detach the 2 claws and disconnect the cable.

    11. A00OURQE01
      Text in Illustration
      *1 Hook
      *2 Hog Ring

      Remove the hog ring and detach the 2 hooks and open the seatback mat.

    12. A00OTVM

      Cut off the cable tie.

    13. A00OVSTE01
      Text in Illustration
      *1 Cable End

      Push the cable to push out the cable end from the clip.

    14. A00OUDV

      Detach the 2 claws and remove the clip.

    15. A00ORP6

      Pull the cable through the hole of the seatback frame.

    16. A00OROIE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, push the headrest support lock to release the lock and remove the front seat headrest assembly.

      Tech Tips

      Tape the screwdriver tip before use.

    17. A00OV0Q

      Detach the 2 claws and remove the 2 front seat headrest supports.

    18. A00OU67

      Detach the 2 hooks and remove the separate type front seatback cover.

  8. REMOVE SEPARATE TYPE FRONT SEATBACK PAD


    1. A00OKVM

      Disconnect the connector.

    2. A00OJNW

      Remove the separate type front seatback pad.

      Note


      • As the front seatback heater assembly is affixed to the separate type front seatback pad, do not remove the front seatback heater assembly from the separate type front seatback pad.

      • When replacing either the front seatback heater assembly or separate type front seatback pad due to a malfunction, be sure to replace both of them with new parts.