FRONT SEAT CUSHION HEATER (for Manual Seat) REMOVAL

Note

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT SEAT ASSEMBLY


    1. Remove the front seat assembly Click here.

  2. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Driver Side)


    1. A010IM5

      Using a screwdriver, detach the 2 claws and remove the cap.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)


    1. A010LKH

      Remove the 2 screws and handle.

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


    1. A010LM3

      Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the release handle.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE FRONT SEAT CUSHION SHIELD LH


    1. A010KEO

      Remove the 2 screws.

    2. Pull the shield to detach the hook and claw.

    3. Remove the cushion shield.

    4. A010I8D

      w/ Lumbar Support:

      Disconnect the connector.

  6. REMOVE FRONT SEAT INNER CUSHION SHIELD LH


    1. A010J3IE01
      Text in Illustration
      *1 Hook
      *2 Wire Harness Clamp

      Remove the 2 screws.

    2. Pull the shield to detach the hook and remove the shield.

    3. Detach the wire harness clamp.

  7. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH


    1. for Driver Side:

      Disconnect the connector and detach the clamps.

    2. for Passenger Side:

      Disconnect the connectors and detach the clamps.

    3. A003CGA

      Remove the nut and front seat inner belt.

  8. REMOVE SEAT CUSHION COVER WITH PAD


    1. A010K9Z

      Detach the 2 hooks and remove the spring.

    2. A010M6T

      Remove the nut and reclining handle.

    3. for Driver Side:


      1. A010KSL

        Detach the clip and remove the connector link.

      2. A010H9Y

        Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle bracket with connector link.

        Tech Tips

        Tape the screwdriver tip before use.

    4. A010J2S

      Detach the 2 rubber bands.

    5. w/ Seat Heater System:


      1. A010GDU

        Cut off the cable tie.

      2. A010J4I

        Disconnect the connector.

    6. for Passenger Side:


      1. A010LZM

        Detach the 2 hooks and remove the connector holder.

    7. A010MAE

      w/ Lumbar Support:

      Detach the wire harness clamp.

    8. w/ Seat Heater System:

      Disconnect the connector.

      A010LAP

    9. Detach the hooks and remove the seat cushion cover with pad.

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER


    1. A003AXE

      Detach the hooks and remove the cushion cover.