AIRBAG CUT-OFF INDICATOR LIGHT REMOVAL


  1. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. A00OSNCE01
      Text in Illustration
      *1 Protective Tape
      *2 Clamp
      *3 Guide

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 2 clips and 5 claws.

    3. Detach the clamp.

    4. Detach the guide near the front of the vehicle and remove the finish panel.

  2. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. A00OURCE01
      Text in Illustration
      *1 Protective Tape
      *2 Clamp
      *3 Guide

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 2 clips and 5 claws.

    3. Detach the clamp.

    4. Detach the guide near the front of the vehicle and remove the finish panel.

  3. REMOVE NO. 3 BOX PANEL


    1. A003B2YE02
      Text in Illustration
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 clips and remove the box panel.

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


    1. Using a moulding remover B, detach the 4 clips and 5 claws and remove the panel end.

      A00OQEVE01

  5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)


    1. A00OSPV

      Using a moulding remover B, detach the 4 clips and 5 claws and remove the panel end.

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for RHD)


    1. w/o TOYOTA Parking Assist-sensor System:


      1. Using a moulding remover B, detach the 4 clips and 5 claws and remove the panel end.

    2. w/ TOYOTA Parking Assist-sensor System:


      1. Using a moulding remover B, detach the 4 clips and 5 claws.

      2. Remove the panel end and then disconnect the connector.

        A00OW4UE01

  7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A006VX0

      Twist the shift lever knob in the direction indicated by the arrow and remove it.

  8. REMOVE REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A006VCT

      Detach the cover.

    2. A006VV0

      Using a moulding remover B, detach the 2 claws.

    3. Detach the 6 clips and remove the console panel.

  9. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL


    1. A006SNF

      Using a moulding remover B, detach the 2 clips.

    2. A006UTXE01
      Text in Illustration
      *1 w/ Seat Heater System

      Remove the finish panel and then disconnect the connectors.

  10. REMOVE TELLTALE LIGHT ASSEMBLY


    1. A00OTGP

      Detach the 2 claws and remove the light.