AIRBAG CUT-OFF SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System for HDD:

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE INSTRUMENT SIDE PANEL RH


    1. A00ORVPE01
      Text in Illustration
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 3 clips and 4 claws.

    3. A00OTT8E01
      Text in Illustration
      *1 w/ Airbag Cut Off Switch Cylinder

      w/ Airbag Cut Off Switch Cylinder:


      1. Disconnect the connector.

    4. Detach the 2 hooks and remove the side panel.

  3. REMOVE AIRBAG CUTOFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A00OU6B

      Detach the 2 claws and remove the cutoff switch cylinder.