SIDE AIRBAG SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH


    1. A00OSDY

      Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note


      • w/ Navigation System for HDD:

        After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    3. Install the side airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the side airbag sensor is not loose.

    5. Connect the connector.

  2. INSTALL LOWER CENTER PILLAR GARNISH LH

    A010OHA

    1. Attach the 2 claws and 3 clips to install the lower center pillar garnish.

  3. INSTALL REAR DOOR SCUFF PLATE LH

    A010S97

    1. Attach the clip and 6 claws to install the front door scuff plate.

  4. INSTALL FRONT DOOR SCUFF PLATE LH

    A010S4G

    1. Attach the 2 clips and 8 claws to install the front door scuff plate.

  5. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    A003CGQE01

    1. Attach the 2 rear hooks of the seat cushion to the seatback.

    2. Attach the 2 front hooks to install the seat cushion.

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.