KNEE AIRBAG ASSEMBLY (for Driver Side) INSTALLATION


  1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. A00OV2W

      Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Attach the 2 claws to install the DLC3.

    3. Attach the 7 claws to install the instrument panel airbag.

    4. Install the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL LOWER STEERING COLUMN COVER


    1. Install the lower steering column cover.

      for Manual Tilt and Manual Telescopic Steering Column: Click here

      for Power Tilt and Power Telescopic Steering Column: Click here

  3. INSTALL LOWER NO. 2 STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)

    A00OMND

    1. Attach the 4 claws to install the lower No. 2 steering column cover.

  4. INSTALL NO. 1 SWITCH HOLE BASE


    1. A00ORTL

      Connect the connectors.

    2. Attach the 2 claws and 4 clips to install the switch hole base.

  5. INSTALL INSTRUMENT SIDE PANEL LH


    1. A00OS50

      Attach the 2 hooks.

    2. A00OV5V

      Attach the 3 clips and 4 claws to install the side panel.

  6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A00OV6B

      Attach the guide.

    2. Connect the connectors.

    3. A00ORBF

      Attach the claw to install the under cover.

    4. Install the 2 screws <A>.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.