AIRBAG SYSTEM, Diagnostic DTC:B1630/23

DTC Code DTC Name
B1630/23 Rear Airbag Sensor RH Circuit Malfunction

DESCRIPTION

The rear airbag sensor RH consists of a safing sensor, diagnostic circuit, lateral deceleration sensor, etc.

If the center airbag sensor assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.

DTC B1630/23 is stored when a malfunction is detected in the rear airbag sensor RH circuit.

DTC Code Detection Condition Trouble Area
B1630/23

One of the following conditions is met:


  • A rear airbag sensor RH malfunction.

  • A center airbag sensor assembly malfunction.

  • Rear airbag sensor RH

  • Center airbag sensor assembly

WIRING DIAGRAM

A00OMS2E01

INSPECTION PROCEDURE

Note


  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  • When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected Click here.

PROCEDURE


  1. CHECK REAR AIRBAG SENSOR RH


    1. A00OHY2E01
      Text in Illustration
      *1 Rear Airbag Sensor LH
      *2 Side Airbag Sensor Assembly RH

      Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

    3. Interchange the rear airbag sensor LH with RH and connect the connectors to them.

    4. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

    5. Turn the ignition switch to ON, and wait for at least 60 seconds.

    6. Clear the DTCs stored in the memory Click here.

    7. Turn the ignition switch off.

    8. Turn the ignition switch to ON, and wait for at least 60 seconds.

    9. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC B1630/23 and B1635/24 are not output A
      DTC B1635/24 is output (for Sedan) B
      DTC B1635/24 is output (for Wagon) C
      DTC B1630/23 is output D

      Tech Tips

      Codes other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

    10. Turn the ignition switch off.

    11. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

    12. Return the rear airbag sensor RH and LH to their original positions and connect the connectors to them.


    B

    REPLACE REAR AIRBAG SENSOR RH Click here

    C

    REPLACE REAR AIRBAG SENSOR RH Click here

    D

    REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here

    A

    USE SIMULATION METHOD TO CHECK Click here