COMBINATION METER REMOVAL


  1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)


    1. Disable the Autoaway/Return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.

    2. Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the ignition switch off.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A00OJJWE01
      Text in Illustration
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 2 clips.

    3. Detach the 5 claws and remove the finish panel.

  5. REMOVE COMBINATION METER ASSEMBLY


    1. A00OHT4

      Remove the 2 screws.

    2. Detach the 2 clips.

    3. A00OL3R

      Disconnect the connector and remove the combination meter.