DOOR COURTESY LIGHT REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A003E08

      Using moulding remover A, detach the 3 claws and remove the bezel plug.

  2. REMOVE ASSIST GRIP COVER LH


    1. A003DSU

      Using moulding remover A, detach the 9 claws and remove the assist grip cover.

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. A003C2CE01

      Using moulding remover A, detach the clip and 7 claws and remove the power window regulator master switch assembly with front door armrest base panel.

    2. Disconnect the connector and remove the power window regulator master switch.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Tech Tips

    Use the same procedure described for the driver side.

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Driver Side)


    1. A003C42E01
      Text in Illustration
      *1 w/ Rear Door Power Window
      *2 w/o Rear Door Power Window

      w/ Rear Door Power Window:


      1. Remove the 3 screws.

      2. Using moulding remover A, detach the 4 claws and remove the master switch assembly.

    2. w/o Rear Door Power Window:


      1. Remove the 3 screws and master switch assembly.

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY

    A003DEV

    1. Detach the 2 claws and remove the regulator switch.

  7. REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION


    1. Remove the front door No. 1 stiffener cushion.

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A003C9T

      Remove the 3 screws.

    2. Remove the 10 clips and 2 claws.

    3. Disconnect the courtesy light connector.

    4. A003BHIE01
      Text in Illustration
      *1 Reference Boss

      Pull out the front door trim board in the direction indicated by the arrow in the illustration to detach the 5 claws of the front inner door glass weatherstrip and remove the reference boss together with the trim board.

    5. Remove the reference boss from the front door trim board.

    6. for Power Seat:


      1. A003B1L

        Detach the wire harness.

      2. A003AMR

        Disconnect the connector.

      3. Disconnect the 2 cables from the inside handle.

    7. A003BQW

      for Manual Seat:

      Disconnect the 2 cables from the inside handle.

  9. REMOVE COURTESY LIGHT ASSEMBLY


    1. A003E87

      Detach the 2 claws and remove the courtesy light.

  10. REMOVE COURTESY LIGHT BULB


    1. A003ATC

      Detach the 3 claws and remove the cover.

    2. Remove the bulb.