DOOR CONTROL RECEIVER (for Sedan Inside Luggage Compartment) INSTALLATION

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL DOOR NO. 2 CONTROL RECEIVER


    1. A003CRP

      Install the door No. 2 control receiver with the bolt.

    2. Connect the connector.

  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH


    1. A00DRBK

      Install the trim cover with the 4 clips.

  3. INSTALL REAR FLOOR FINISH PLATE


    1. A00DQPN

      Attach the 4 clips to install the rear floor finish plate.

    2. A00DPVX

      Install the 2 clips.

  4. INSTALL ROPE HOOK ASSEMBLY


    1. A00DQ4Z

      Install the 4 rope hooks with the 4 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

  5. INSTALL REAR FLOOR BOARD SPACER

    A00DS4UE01

  6. INSTALL LUGGAGE COMPARTMENT FLOOR CARPET

    A00DV1K

  7. INSTALL REAR SIDE SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    A003CGQE01

    1. Attach the 2 rear hooks of the seat cushion to the seatback.

    2. Attach the 2 front hooks to install the seat cushion.

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.