GENERATOR (for 100 A Type) REMOVAL


  1. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER


    1. A00ORGX

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  5. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A00OVQR

      Remove the 7 clips and radiator support opening cover.

  6. REMOVE FRONT LOWER BUMPER ABSORBER


    1. A00OVPY

      Remove the 4 screws and 2 bolts.

    2. A00OUR6

      Remove the 8 bolts and 3 screws.

    3. Detach the 2 hooks of the front lower bumper absorber from the installation holes on the body and remove the front lower bumper absorber.

  7. REMOVE ENGINE UNDER COVER


    1. A00ORDS

      Remove the 11 clips and engine under cover.

  8. REMOVE REAR ENGINE UNDER COVER RH


    1. Remove the 5 clips and rear engine under cover RH.

  9. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A00OVDV

      Remove the 4 bolts and front suspension member reinforcement.

  10. REMOVE FAN AND GENERATOR V BELT


    1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the belt.

      A00OTC1E01
      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note

      Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.

  11. REMOVE GENERATOR ASSEMBLY


    1. Remove the terminal cap.

    2. A00OU1K

      Disconnect the generator connector and detach the clamp.

    3. Remove the nut and disconnect the generator wire from terminal B.

    4. Remove the bolt and wire harness clamp bracket.

    5. A00OVTG

      Remove the 3 bolts and generator.