REAR VIEW MONITOR SYSTEM (for Inner Rear View Mirror Type) Inner Rear View Mirror Power Source Circuit

DESCRIPTION

This circuit detects the state of the ignition switch, and sends it to the inner rear view mirror assembly.

WIRING DIAGRAM

A00E6L3E02

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BATTERY AND BODY GROUND)


    1. A00E9TCE03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Inner Rear View Mirror Assembly)

      Disconnect the K12 inner rear view mirror assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      K12-1 (IG) - K12-2 (E) Ignition switch ON 11 to 14 V
      Ignition switch off Below 1 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K12-2 (E) - Body ground Always Below 1Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here