NAVIGATION SYSTEM (for DVD) HOW TO PROCEED WITH TROUBLESHOOTING

VEHICLE BROUGHT TO WORKSHOP

NEXT

INSPECT BATTERY VOLTAGE

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT

BASIC INSPECTION

1. Turn the ignition switch to ACC.

2. Check whether or not the display appears on the navigation receiver assembly.

   Result

   Result	Proceed to
   Display appears	A
   Display does not appear	B

   
   

   B

   Go to step 6

   A

CHECK FOR DTC

1. Check for DTCs and note any codes that are output.

2. Clear the DTCs.

3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the navigation system DTCs by simulating the conditions indicated by the DTCs.

   Tech Tips

   
   

   • If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal and repair or replace problem parts.

   • Even if the malfunction symptom is not confirmed, check for DTCs as the system stores past DTCs.

   • Refer to the detailed description on the diagnostic screen as necessary Click here.

   • Check and clear past diagnostic trouble codes. Check the diagnostic trouble code and inspect the area the code indicates.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   
   

   B

   Go to step 7

   A

PROBLEM SYMPTOMS TABLE

B

Go to step 7

A

OVERALL ANALYSIS AND TROUBLESHOOTING

1. Terminals of ECU Click here.

2. Inspect the front No. 1 speaker Click here.

3. Inspect the front No. 2 speaker Click here.

4. Inspect the rear No. 1 speaker Click here.

5. Inspect the steering pad switch Click here.

   
   

   NEXT

ADJUST, REPAIR OR REPLACE

NEXT