DIGITAL AUDIO BROADCASTING ANTENNA (for Sedan) INSTALLATION


  1. INSTALL DIGITAL AUDIO BROADCASTING ANTENNA ASSEMBLY


    1. Install the digital audio broadcasting antenna assembly with bolt.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Connect each connector.

  2. INSTALL INNER ROOF SIDE GARNISH LH

    A010SAYE01
    Text in Illustration
    *1 Clip A

    1. Install 2 new clips labeled A to the inner roof side garnish.

    2. Attach the 5 clips to install the inner roof side garnish.

  3. INSTALL REAR SIDE SEATBACK ASSEMBLY LH


    1. A003BE1E01

      Install the claw as shown in the illustration.

    2. Install the side seatback with the bolt.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }
    3. A003CVN

      Install the rear seat 3 point type belt anchor with the bolt.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

      Note

      Do not allow the anchor part of the rear seat 3 point type belt to overlap the protruding parts of the floor panel.

    4. Install the seat belt to the belt guide.

    5. Attach the claw to close the cap of the rear seat shoulder belt guide.

    6. Check if the ELR locks.

      Note

      The check should be performed with the outer belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  4. INSTALL REAR BENCH TYPE SEAT CUSHION ASSEMBLY

    A003CGQE01

    1. Attach the 2 rear hooks of the seat cushion to the seatback.

    2. Attach the 2 front hooks to install the seat cushion.

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.