NAVIGATION SYSTEM, Diagnostic DTC:B1579

DTC Code DTC Name
B1579 Voice Recognition Microphone Disconnected

DESCRIPTION

The radio and display receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.

This DTC is stored when the microphone connection detection signal is disconnected.

DTC Code DTC Detection Condition Trouble Area
B1579 Telephone microphone signal is lost.

  • Telephone microphone assembly

  • Map light assembly

  • Radio and display receiver assembly

  • Harness or connector

WIRING DIAGRAM

A010PHUE05

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


    1. A010QN3E01
      Text in Illustration
      *a

      Component with harness connected

      (Radio and Display Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D124-19 (MIN-) - Body ground Always Below 1 Ω

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)


    1. Disconnect the D124 radio and display receiver assembly connector.

    2. Disconnect the K15 map light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D124-6 (SNS2) - K15-5 (SNS2) Always Below 1 Ω
      D124-19 (MIN-) - K15-14 (MIC-) Always Below 1 Ω
      D124-6 (SNS2) - Body ground Always 10 kΩ or higher
      D124-19 (MIN-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK MAP LIGHT ASSEMBLY


    1. A010N6PE08

      Remove the map light assembly Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      5 (SNS2) - 14 (MIC-) Always Below 1 Ω

    NG

    INSPECT TELEPHONE MICROPHONE ASSEMBLY Click here

    OK

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here

  4. INSPECT TELEPHONE MICROPHONE ASSEMBLY


    1. A010NJV

      Remove the telephone microphone assembly Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Always Below 1 Ω

    NG

    REPLACE TELEPHONE MICROPHONE ASSEMBLY Click here

    OK

    REPLACE MAP LIGHT ASSEMBLY Click here