DESCRIPTION
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C13AE/72 | Incoherent information is detected in the non-volatile memory. |
|
INSPECTION PROCEDURE
Note
Before performing work, turn the ignition switch off and wait approximately 20 seconds to make sure that the parking brake cannot operate.
When replacing the parking brake with bracket actuator assembly, perform zero point calibration Click here.
Tech Tips
When DTC U0073/51, U0100/53, U0124/55 and/or U0129/52 is output together with DTC C13AE/72, inspect and repair trouble areas indicated by DTC U0073/51, U0100/53, U0124/55 and/or U0129/52 first Click here.
PROCEDURE
CLEAR DTC
Clear the DTCs Click here.
| NEXT |
|
CHECK DTC
Drive the vehicle at 30 km/h (19 mph) or more for 5 seconds or more.
Check for DTCs Click here.
| Result | Proceed to |
|---|---|
| DTC is output. | A |
| DTC is not output. | B |
| B |
|
USE SIMULATION METHOD TO CHECK Click here |
| A |
|
READ VALUE USING INTELLIGENT TESTER (COMMUNICATION MAIN BODY)
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Select the Data List mode on the intelligent tester Click here.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Communication Main Body | Communication with main body ECU/ ON or OFF |
ON: Ignition switch ON OFF: Ignition switch off |
- |
| Result | Proceed to |
|---|---|
| ON is displayed when the ignition switch is ON | A |
| OFF is displayed when the ignition switch is ON | B |
| B |
|
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
| A |
|
REPLACE PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY Click here