STEERING ANGLE SENSOR INSTALLATION


  1. INSTALL SPIRAL CABLE SUB-ASSEMBLY


    1. A003EP4

      Attach the 3 claws to install the spiral cable.

    2. Connect the connectors to the spiral cable.

  2. INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)

    Note

    If the steering column cover is installed in an incorrect order, it will not be possible to assemble the steering column cover.


    1. A00ONF4

      Attach the claw and 2 pins to install the upper steering column cover.

  3. INSTALL STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic Steering Column)

    Note

    If the steering column cover is installed in an incorrect order, it will not be possible to assemble the steering column cover.


    1. A00OQIO

      Attach the claw and 2 pins to install the upper steering column cover.

  4. INSTALL LOWER NO. 2 STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)

  5. ADJUST SPIRAL CABLE SUB-ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A00OVPL

      Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

    4. A00OVY3

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

      Tech Tips

      The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

  6. INSTALL STEERING WHEEL ASSEMBLY


    1. Install the steering wheel assembly Click here.