REAR TRAILING ARM REMOVAL


  1. REMOVE REAR WHEEL

  2. DISCONNECT PARKING BRAKE CABLE


    1. A003DLQ

      Remove the clamp.

    2. Remove the bolt and clamp.

      A003BVG

    3. Remove the 2 nuts and casing cap.

    4. A003DIY

      Remove the bolt and clamp from the trailing arm LH.

    5. A003AZ1

      Remove the bolt and clamp from the trailing arm RH.

  3. DISCONNECT SKID CONTROL SENSOR WIRE


    1. Disconnect the skid control sensor wire connector from the vehicle side connector on the rear floor.

    2. A003DZ0

      Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.

    3. A003D5Y

      Remove the bolt and sensor clamp from the wheel house gusset.

    4. A003CXW

      Remove the bolt and sensor clamp from the trailing arm bracket.

    5. A003CMOE01

      Detach the sensor clamp.

    6. Disconnect the connector.

  4. DISCONNECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    1. for Turnbuckle Type:


      1. A00OQIQ

        Remove the bolt and nut, and disconnect the rear No. 1 suspension arm from the suspension member.

        Note

        Since a stopper nut is used, loosen the bolt.

    2. for Cam Type:


      1. A00OQDVE01
        Text in Illustration
        *a Matchmarks

        Place matchmarks on the No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear suspension member sub-assembly.

      2. Remove the nut, No. 2 camber adjust cam and rear suspension toe adjust cam sub-assembly.

        Note

        Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

      3. Separate the rear No. 1 suspension arm assembly from the rear suspension member sub-assembly.

  5. REMOVE REAR TRAILING ARM ASSEMBLY

    A00OS8T

    1. Remove the 4 bolts and trailing arm from the axle carrier and suspension member.