REAR UPPER ARM INSTALLATION


  1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

    A003C70

    1. Temporarily install the rear upper control arm to the rear suspension member and rear axle carrier with the 2 bolts and 2 nuts.

  2. STABILIZE SUSPENSION


    1. Install the rear wheel.

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

    2. Lower the vehicle and bounce it up and down several times to stabilize the rear suspension.

    3. Remove the rear wheel.

  3. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

    A003BS3

    1. Using a jack and wooden block, raise the vehicle so that the rear No. 2 suspension arm assembly LH is at the standard vehicle height to apply load to the rear suspension.

    2. A003C70

      Tighten the 2 bolts and 2 nuts of the upper control arm.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

      Note

      Since a stopper nut is used, tighten the bolt.

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT


    1. Inspect and adjust the rear wheel alignment Click here.