REAR AXLE HUB REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. Remove the rear disc brake cylinder assembly LH Click here.

  2. REMOVE REAR DISC


    1. A00OQLPE01
      Text in Illustration
      *1 Matchmark

      Place matchmarks on the disc and axle hub.

    2. Remove the rear disc.

  3. DISCONNECT SKID CONTROL SENSOR WIRE


    1. Disconnect the skid control sensor wire connector from the vehicle side connector on the rear floor.

    2. A003DZ0

      Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.

    3. A003D5Y

      Remove the bolt and sensor clamp from the wheel house gusset.

    4. A003CXW

      Remove the bolt and sensor clamp from the trailing arm bracket.

    5. A003CMOE01

      Detach the sensor clamp.

    6. Disconnect the connector.

  4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH


    1. A003E50

      Remove the 4 bolts and the rear axle hub and bearing assembly.