TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the front exhaust pipe assembly Click here.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A00OVQR

      Remove the 7 clips and radiator support opening cover.

  3. REMOVE NO. 1 ENGINE COVER


    1. A00ORGX

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  4. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A00OVAG

      Disconnect the starter connector.

    2. Open the terminal cap, remove the nut and disconnect the starter wire.

    3. Remove the 2 bolts and starter.

  5. REMOVE BATTERY

  6. REMOVE BATTERY TRAY

  7. REMOVE BATTERY CARRIER


    1. A00OU72

      Detach the 2 clamps and disconnect the wire harness.

    2. Remove the 4 bolts and battery carrier.

  8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A010QON

      Disconnect the mass air flow meter connector.

    2. Disconnect the No. 2 ventilation hose.

    3. Disconnect the air cleaner hose.

    4. Detach the 4 clamps and remove the air cleaner cap.

  9. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  10. REMOVE AIR CLEANER CASE


    1. A010O7W

      Remove the 3 bolts and air cleaner case.

  11. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  12. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    A010SS0

    1. Remove the 3 nuts and front No. 1 floor heat insulator.

  13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A010OJU

      Remove the 2 clips and disconnect the 2 cables from the transaxle.

    2. A010SAN

      Remove the 2 clips and disconnect the 2 cables from the control cable bracket.

    3. A010Q4M

      Remove the bolt and detach the bracket of the control cable assembly.

    4. A010SXW

      Remove the 2 nuts and detach the grommet of the control cable assembly.

    5. A010N75

      Remove the clip and disconnect the end of the select control cable.

    6. A010QR3

      Remove the clip and the end of the shift control cable.

    7. A010PLW

      Detach the claws and remove the control cable assembly.