SHIFT LEVER ASSEMBLY INSTALLATION

INSTALL FLOOR SHIFT LEVER ASSEMBLY
1. Attach the 2 claws to connect the shift control cable and select control cable to the shift lever assembly.
2. Connect the end of the shift control cable to the shift lever assembly and install the clip.
3. Install the shift lever assembly with the 4 bolts.
  
  Torque:
  
  12 N*m { 122 kgf*cm, 9 ft.*lbf }
4. Attach the 3 wire harness clamps.
5. Release the lock of the cable length adjustment structure of the select cable.
  1. Twist the stopper.
  2. Pull the lock piece outward from the case to release the lock.
6. Pressing the shift and select lever shaft (*1) and pin (*2), push in pin (*3) and check that the shift and select lever shaft is secured at the 1st-2nd gear selected position (the shaft comes to a stop at the position 8 mm (0.315 in.) below the N position).
7. Connect the end of the select control cable to the shift lever assembly and install the clip.
  Note
  
  Make sure the lock piece of the select control cable is facing upward when the select control cable is connected.
  
  Make sure the clip is inserted in the direction shown in the illustration.
8. Text in Illustration
  
  *1 Slider
  
  *2 Inhibitor Wall
  
  Push the slider against the inhibitor wall.
  Note
  
  Do not pull up the slider.
  
  When adjusting the cable, make sure that the shift lever is not in 1 or 2.
9. Lock the cable length adjustment structure of the select cable.
  1. Push the lock piece into the case with slider held against the inhibitor wall.
  2. Return the stopper to prevent the lock from being released.
    
    Note
    
    Push in the lock piece completely.
    
    Make sure that the cable length adjustment structure is locked securely.
10. Release the pin that fixes the transmission outer lever.
  1. Pull the pin toward the left front side of the vehicle.
INSTALL CONSOLE BOX ASSEMBLY

w/ Console Box Lid Click here

w/o Console Box Lid Click here

Text in Illustration
*1	Slider
*2	Inhibitor Wall