CLUTCH PEDAL SWITCH INSTALLATION


  1. INSTALL CLUTCH START SWITCH ASSEMBLY

    A003DG7E01

    1. Install the clutch start switch assembly with the nut.

      Torque:
      16 N*m  { 160 kgf*cm, 12 ft.*lbf }

    2. Connect the clutch start switch assembly connector.

    3. A003CU3E02

      With the clutch pedal fully depressed, check the clearance.

      Clearance between Pedal and Switch Body
      Item Specified Condition
      for LHD 1.7 to 4.7 mm (0.0669 to 0.185 in.)
      for RHD 2.7 to 5.7 mm (0.106 to 0.224 in.)

  2. INSPECT CLUTCH START SWITCH ASSEMBLY


    1. A00E7GAE25
      Text in Illustration
      *1 7.65 to 8.35 mm (0.301 to 0.329 in.)

      Check for continuity between the terminals when the switch is on and off.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 On (pushed) Below 1 Ω
      Off (free) 10 kΩ or higher

      If the result is not as specified, replace the clutch start switch assembly.