CLUTCH UNIT (for 2AD-FTV) INSTALLATION


  1. INSTALL CLUTCH DISC ASSEMBLY


    1. A00E7VJE01

      Insert SST into the clutch disc, and then insert them into the flywheel.

      SST
      09301-00310

      Note

      Insert the clutch disc with the disc facing the correct direction.

  2. INSTALL CLUTCH COVER ASSEMBLY


    1. A00E96UE01
      Text in Illustration
      *1 Matchmark

      Align the matchmark on the clutch cover with the one on the flywheel.

    2. Install and tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

      Torque:
      19 N*m  { 195 kgf*cm, 14 ft.*lbf }

      Note


      • Be sure to uniformly tighten the bolts 180° at a time according to the order in the illustration.

      • Move SST up and down, right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.

  3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


    1. A00E734E01

      Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

      Maximum misalignment
      1.3 mm (0.0512 in.)

      If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.

      SST
      09333-00013

  4. INSTALL RELEASE FORK SUPPORT


    1. A00E9HU

      Install the release fork support to the manual transaxle assembly.

      Torque:
      37 N*m  { 375 kgf*cm, 27 ft.*lbf }

  5. INSTALL CLUTCH RELEASE FORK BOOT


    1. A00E927

      Install the clutch release fork boot to the manual transaxle assembly.

  6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

    A00E87NE01
    Text in Illustration
    *1 Multemp 8158 Grease or equivalent

    1. Apply release hub grease to the release fork where it contacts the release bearing, push rod and release fork support.

      Grease
      Multemp 8158 Grease or equivalent

    2. Install the release fork to the release bearing with the clip.

  7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

    A00E9V4E01

    1. Apply clutch spline grease to the input shaft spline.

      Grease
      Toyota Genuine Clutch Spline Grease or equivalent
      Text in Illustration
      *1 Clutch spline grease
    2. A00E8U7

      Install the clutch release bearing together with the release fork to the manual transaxle assembly.

      Note

      After the installation, move the fork forward and backward to check that the release bearing slides smoothly.

  8. INSTALL MANUAL TRANSAXLE ASSEMBLY


    1. Install the manual transaxle assembly Click here.