HEATER ASSEMBLY REMOVAL


  1. REMOVE NO. 1 ENGINE COVER


    1. A00ORGX

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE FRONT WIPER ARM HEAD CAP


    1. A00OJK6

      Using a screwdriver, remove the front wiper arm head cap.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for all front wiper arm head caps.

  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A00ONYS

      Remove the nut and the front wiper arm and blade assembly LH.

  4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A00OM49

      Remove the nut and the front wiper arm and blade assembly RH.

  5. REMOVE HOOD TO COWL TOP SEAL


    1. A00OKSF

      Using a clip remover, detach the 6 clips and 2 claws and remove the hood to cowl top seal.

  6. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A00OJHX

      Remove the clip.

    2. Detach the 8 claws and remove the cowl top ventilator louver RH.

  7. REMOVE COWL TOP VENTILATOR LOUVER LH


    1. A00ONZA

      Remove the clip.

    2. Detach the 5 claws and remove the cowl top ventilator louver LH.

  8. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    1. A00OIY3

      Disconnect the connector. Then detach the clamp and remove the wire harness from the cowl top panel.

    2. A00OIUJ

      Remove the 2 bolts.

    3. A00OKC9

      Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body and remove the wiper motor and link.

  9. REMOVE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY (for DPF)


    1. A003D5G

      Detach the wire harness clamp and disconnect the sensor connector.

    2. Remove the bolt and sensor.

    3. Disconnect the 2 vacuum hoses.

  10. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    1. A00ORFK

      Disconnect the connector and detach the harness clamp.

    2. A00OTJV

      Remove the 9 bolts and outer cowl top panel.

  11. REMOVE AIR DUCT


    1. A00OVTM

      Remove the clip and air duct.

  12. REMOVE NO. 1 EXHAUST PIPE SUB-ASSEMBLY


    1. A00ORZO

      Remove the 3 nuts and No. 1 exhaust pipe sub-assembly.

  13. REMOVE HEATER WITH EXHAUST PIPE ASSEMBLY

    A00OU91

    1. Disconnect the connector.

    2. Remove the 3 clips.

    3. Detach the clamp.

    4. A00OU7F

      Remove the 3 nuts and heater with exhaust pipe assembly.