ROOM TEMPERATURE SENSOR (for Automatic Air Conditioning System) REMOVAL

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A00OVEV

      Remove the 2 screws <A>.

    2. Detach the claw.

    3. A00OV6B

      Disconnect the connectors.

    4. Detach the guide and remove the under cover.

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. A00ORW6

      Remove the 4 bolts.

    2. Detach the 7 claws and remove the instrument panel airbag.

    3. Detach the 2 claws and disconnect the DLC3.

    4. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  5. REMOVE ROOM TEMPERATURE SENSOR

    A00OUB8

    1. Disconnect the connector.

    2. Disconnect the hose and remove the sensor.