CONDENSER REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. Remove the front bumper cover Click here.

  2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. Start the engine.

    2. Turn the A/C switch on.

    3. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

    4. Stop the engine.

    5. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  3. REMOVE OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)

    A006U6B

    1. Remove the 2 bolts, nut and oil cooler assembly.

  4. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

  5. REMOVE RADIATOR GRILLE BRACKET


    1. A006SGT

      Remove 2 bolts, nut and radiator grille bracket.

  6. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

    A006VJ9

    1. Remove the bolt and disconnect the discharge hose sub-assembly from the condenser.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

    2. Remove the O-ring from the discharge hose sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  7. DISCONNECT SUCTION PIPE SUB-ASSEMBLY

    A006WAG

    1. Remove the bolt and disconnect the suction pipe sub-assembly from the condenser.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

    2. Remove the O-ring from the suction pipe sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  8. REMOVE UPPER RADIATOR SUPPORT


    1. A006THT

      Remove the 2 bolts and 2 upper radiator supports.

    2. Remove the 2 radiator support cushions.

  9. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY


    1. A006SJI

      Remove the 4 bolts, upper radiator support sub-assembly LH and upper radiator support sub-assembly RH.

  10. REMOVE CONDENSER ASSEMBLY WITH RECEIVER


    1. A006X67

      Remove the condenser assembly with receiver as shown in the illustration.