CHILD RESTRAINT SEAT TETHER ANCHOR (for Sedan) REMOVAL


  1. REMOVE REAR BENCH TYPE SEAT CUSHION ASSEMBLY

    A003ATB

    1. Detach the 2 front hooks of the seat cushion from the vehicle body.

      Note

      Follow the instructions below carefully as the cushion frame deforms easily.


      1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

      2. Repeat for the other hook.

    2. Detach the 2 rear hooks of the seat cushion from the seatback.

      Note

      Be careful not to damage the vehicle body.

  2. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    A003CVN

    1. Remove the bolt and disconnect the rear seat 3 point type belt anchor.

    2. A003AHX

      Using a screwdriver, detach the claw to open the cap of the rear seat shoulder belt guide.

    3. Remove the seat belt from the belt guide.

    4. A003CZ2E01

      Remove the bolt, and then remove the side seatback LH as shown in the illustration.

  3. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.

  4. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

    A003BSL

    1. Remove the bolt and disconnect the center seat outer belt anchor.

  5. REMOVE INNER ROOF SIDE GARNISH LH

    A00E7N4E01
    Text in Illustration
    *1 Clip A

    1. Detach the 5 clips and remove the inner roof side garnish.

      Tech Tips

      The 2 clips labeled A remain attached to the body.

    2. Remove the 2 clips labeled A from the vehicle body.

  6. REMOVE INNER ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  7. REMOVE REAR SEAT SHOULDER BELT HOLE COVER

    A003AYJ

    1. Using a moulding remover, detach the 4 claws and remove the belt hole cover.

      Tech Tips

      Use the same procedure to remove all the belt hole covers.

  8. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    A003D40

    1. Disconnect the connector.

    2. Remove the 4 clips.

    3. Detach the 2 clips and raise the front portion of the package tray trim panel assembly.

    4. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    5. Detach the 5 claws and remove the package tray trim panel assembly.

  9. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER

    A003DET

    1. Detach the 2 clips and 2 claws, and remove the anchor cover.

      Tech Tips

      Use the same procedure to remove the other child restraint seat tether anchor cover.

  10. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET

    A003CWU

    1. Remove the bolt and child restraint seat tether anchor bracket.

      Tech Tips

      Use the same procedure to install the other child restraint seat anchor bracket.