FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE LH

    A010S4G

    1. Detach the 8 claws and 2 clips, and remove the front door scuff plate.

  4. REMOVE REAR DOOR SCUFF PLATE LH

    A010S97

    1. Detach the 6 claws and clip, and remove the rear door scuff plate.

  5. REMOVE LOWER CENTER PILLAR GARNISH LH

    A010OHA

    1. Detach the 2 claws and 3 clips, and remove the lower center pillar garnish.

  6. REMOVE LAP BELT OUTER ANCHOR COVER

    A010NB4

    Tech Tips

    Use the same procedure for the other lap belt outer anchor cover.


    1. Detach the 3 claws and remove the lap belt outer anchor cover.

  7. REMOVE CENTER PILLAR GARNISH LH

    A010RTF

    1. Remove the bolt and disconnect the front seat outer belt floor anchor.

    2. A010OB6

      Remove the 2 screws.

    3. Detach the clip.

    4. Pass the front seat outer belt floor anchor through the center pillar garnish, and remove the center pillar garnish.

  8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

    A010SRR

    1. Remove the nut and shoulder anchor.

    2. A010QEF

      w/o Pre-crash Safety System:

      Disconnect the pretensioner connector as shown in the illustration.

    3. A010PYK

      w/ Pre-crash Safety System:


      1. Disconnect the pretensioner connector as shown in the illustration.

      2. Disconnect the connector.

    4. A010N4Y

      Remove the 2 bolts and seat belt.

  9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    A010OFD

    1. Remove the 2 bolts and adjuster.