FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System for HDD:

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT DOOR SCUFF PLATE LH

    A00EA17

    1. Detach the 8 claws and 2 clips, and remove the front door scuff plate.

  3. REMOVE REAR DOOR SCUFF PLATE LH

    A00EBB8

    1. Detach the 6 claws and clip, and remove the rear door scuff plate.

  4. REMOVE LOWER CENTER PILLAR GARNISH LH

    A00E8QB

    1. Detach the 2 claws and 3 clips, and remove the lower center pillar garnish.

  5. REMOVE LAP BELT OUTER ANCHOR COVER

    A00EBEO

    Tech Tips

    Use the same procedure for the other lap belt outer anchor cover.


    1. Detach the 3 claws and remove the lap belt outer anchor cover.

  6. REMOVE CENTER PILLAR GARNISH LH

    A00E8QB

    1. Detach the 2 claws and 3 clips, and remove the lower center pillar garnish.

  7. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

    A006SOQ

    1. Remove the nut and shoulder anchor.

    2. A006V5I

      w/o Pre-crash Safety System:

      Disconnect the pretensioner connector as shown in the illustration.

    3. A006VK9

      w/ Pre-crash Safety System:


      1. Disconnect the pretensioner connector as shown in the illustration.

      2. Disconnect the connector.

    4. A006VUY

      Remove the 2 bolts and seat belt.

  8. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    A006UOO

    1. Remove the 2 bolts and adjuster.