OIL PRESSURE SWITCHING VALVE INSTALLATION


  1. INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY


    1. A00OR21E01
      Text in Illustration
      *1 O-Ring

      Apply a light coat of engine oil to the O-ring of the oil pressure switching valve.

    2. Install the oil pressure switching valve with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed when installing the oil pressure switching valve.

    3. Connect the oil pressure switching valve connector and attach the wire harness clamp.

  2. ADD ENGINE OIL


    1. Add new engine oil.

      Standard Oil Grade
      Item Oil Grade Oil Viscosity (SAE)

      for CCo:

      Diesel fuel that contains between 50 ppm and 500 ppm of sulfur

      G-DLD1, ACEA B1, API CF-4 or CF

      (You may also use API CE or CD)

      - 5W-30

      - 10W-30

      - 15W-40

      - 20W-50

      for CCo:

      Diesel fuel that contains 50 ppm or less of sulfur

      G-DLD1, ACEA C2, ACEA B1, API CF-4 or CF

      (You may also use API CE or CD)

      - 0W-30

      - 5W-30

      - 10W-30

      - 15W-40

      - 20W-50
      for DPF ACEA C2

      - 0W-30

      - 5W-30
      Standard Capacity (for CCo)
      Item Specified Condition
      Drain and refill without oil filter change 5.9 liters (6.2 US qts, 5.2 Imp. qts)
      Drain and refill with oil filter change 6.3 liters (6.7 US qts, 5.5 Imp. qts)
      Dry fill 7.1 liters (7.5 US qts, 6.2 Imp. qts)
      Standard Capacity (for DPF)
      Item Specified Condition
      Drain and refill without oil filter change 5.5 liters (5.8 US qts, 4.8 Imp. qts)
      Drain and refill with oil filter change 5.9 liters (6.2 US qts, 5.2 Imp. qts)
      Dry fill 6.7 liters (7.1 US qts, 5.9 Imp. qts)

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.

      If low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill engine oil above the full level mark.

  5. INSTALL ENGINE UNDER COVER


    1. A00OS6I

      Install the engine under cover with the 8 clips.