OIL PRESSURE SENSOR REMOVAL


  1. REMOVE ENGINE UNDER COVER


    1. A00OSII

      Remove the 8 clips and fold back the engine under cover.

      Tech Tips

      It is not necessary to fully remove the engine under cover. Partially remove it so that the oil can be replaced in a later step.

  2. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

    3. Install a new gasket and the oil pan drain plug.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

  3. REMOVE NO. 1 ENGINE COVER


    1. A00ORGX

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  4. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A00OVQR

      Remove the 7 clips and radiator support opening cover.

  5. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. Disconnect the oil pressure sender gauge connector.

    2. A00OTKB

      Using a 27 mm deep socket wrench, remove the oil pressure sender gauge.