DIFFERENTIAL PRESSURE SENSOR ON-VEHICLE INSPECTION

CHECK DIFFERENTIAL PRESSURE SENSOR
1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the intelligent tester on.
4. Enter the following menus: Powertrain / Engine / Data List / DPNR Differential Pressure.
5. Disconnect the No. 1 vacuum transmitting hose from the sensor.
6. Using SST, apply pressure to the sensor.
  
  SST
  
  09992-00242
7. Check the pressure value of the sensor.
  
  Standard pressure
  
  Approximately the same pressure as the applied pressure is indicated on the tester.
  
  Note
  
  Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm², 0 to 14.2 psi).
  
  If the result is not as specified, check the sensor circuit.
  - w/ Gear Shift Indicator: Click here
  - w/o Gear Shift Indicator: Click here
8. Connect the No. 1 vacuum transmitting hose to the sensor.