DRIVE BELT REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER


    1. A003DQW

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE REAR ENGINE UNDER COVER RH


    1. A00OQG7

      Remove the 5 clips and under cover.

  3. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A00OVDV

      Remove the 4 bolts and front suspension member reinforcement.

  4. REMOVE FAN AND GENERATOR V BELT


    1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the belt.

      A00OTC1E01
      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note

      Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.