CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER


    1. A003DQW

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE CAMSHAFT POSITION SENSOR


    1. A003C9V

      Disconnect the sensor connector.

    2. Remove the bolt and sensor.