INTAKE AIR TEMPERATURE SENSOR INSTALLATION


  1. INSTALL INTAKE AIR TEMPERATURE SENSOR


    1. A006W8I

      Install a new gasket to the sensor.

    2. Using a 22 mm ball joint lock nut wrench, install the sensor.

      Torque:
      34 N*m  { 350 kgf*cm, 25 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench Click here.

    3. Connect the sensor connector.

  2. INSTALL ENGINE UNDER COVER


    1. Install the engine under cover with the 11 clips.

  3. INSTALL FRONT LOWER BUMPER ABSORBER


    1. Insert the 2 hooks of the front lower bumper absorber into the installation holes on the body to install the front lower bumper absorber.

    2. Install the 8 bolts and 3 screws.

    3. Install the 4 screws and 2 bolts.