DYNAMIC RADAR CRUISE CONTROL SYSTEM ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the driving support ECU.

WIRING DIAGRAM

A006TV2E01

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU - BATTERY AND BODY GROUND)


    1. A006T22E01
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Driving Support ECU)

      Disconnect the D14 ECU connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      D14-30 (B) - Body ground Ignition switch ON 11 to 14 V
      Ignition switch off Below 1 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D14-25 (GND) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here