RELAY ON-VEHICLE INSPECTION


  1. INSPECT STARTER RELAY (ST)


    1. A019F0OE26

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the starter relay.

  2. INSPECT ACC RELAY


    1. A019F0OE26

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the ACC relay.

  3. INSPECT GLOW RELAY


    1. A019GNY

      Remove the bolt.

    2. Disconnect the connector and remove the relay.

    3. A019HOCE01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Battery voltage not applied to terminals 3 and 4 10 kΩ or higher
      Battery voltage applied to terminals 3 and 4 Below 1 Ω

      If the result is not as specified, replace the glow relay.

    4. Connect the connector and install the relay with the bolt.

      Torque:
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }