GLOW PLUG CONTROLLER REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A00OQGF

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp from the battery carrier, and then remove the battery clamp.

  5. REMOVE BATTERY INSULATOR

  6. REMOVE BATTERY

  7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A010QON

      Disconnect the mass air flow meter connector.

    2. Disconnect the No. 2 ventilation hose.

    3. Disconnect the air cleaner hose.

    4. Detach the 4 clamps and remove the air cleaner cap.

  8. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  9. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A010O7W

      Remove the 3 bolts and air cleaner case.

  10. REMOVE NO. 1 AIR CLEANER INLET


    1. A00OSS9

      Detach the clip and remove the No. 1 air cleaner inlet.

  11. REMOVE NO. 2 AIR CLEANER INLET


    1. A00OT6Q

      Remove the bolt and No. 2 air cleaner inlet.

  12. REMOVE GLOW PLUG CONTROLLER


    1. A00OVB1

      Remove the 2 bolts and glow plug controller.

    2. Disconnect the 4 connectors.

  13. REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET


    1. A00OW3D

      Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.