ATF TEMPERATURE SENSOR INSTALLATION


  1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY

    A006UG2E03
    Text in Illustration
    *1 New O-ring

    1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.

    2. Coat the 4 bolts with ATF.

    3. A006VFQE08
      Text in Illustration
      *1 Clamp

      Install the ATF temperature sensor and clamp to the valve body with the 4 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      Bolt A: 25 mm (0.984 in.)

      Bolt B: 85 mm (3.35 in.)

    4. Connect the connector.

  2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A00E8TD

    1. Coat a new O-ring with ATF and install it to the oil strainer.

      Note

      Ensure that the O-ring is not twisted or pinched.

    2. A00E80G

      Install the oil strainer to the valve body with the 2 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

    A00E713E05

    1. Install the 2 magnets to the oil pan.

      Text in Illustration
      *1 Magnet

    2. Install a new gasket to the oil pan.

    3. A00E9GSE01

      Apply seal packing to the bolt labeled A in the illustration.

      Seal packing
      Toyota Genuine Seal Packing 1281,
      Three Bond 1281 or equivalent

    4. Install the oil pan to the automatic transaxle with the 18 bolts.

      Torque:
      for bolt labeled A
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
      for other bolts
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • In order to ensure proper sealing of the transmission oil pan bolt, apply seal packing to the bolt and install it within 10 minutes of seal packing application.

      • Completely remove any oil or grease from the contact surfaces of the transaxle case, oil pan sub-assembly and gasket before installation.

  4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH

    A00EA6F

    1. Install the front suspension member reinforcement with the 4 bolts.

      Torque:
      96 N*m  { 979 kgf*cm, 71 ft.*lbf }

  5. ADD AUTOMATIC TRANSAXLE FLUID


    1. Add automatic transaxle fluid Click here.

  6. INSTALL REAR ENGINE UNDER COVER LH


    1. Install the under cover with the 5 clips.

  7. INSTALL NO. 1 ENGINE UNDER COVER


    1. A00EB0Y

      Install the engine under cover with the 11 clips.

  8. INSTALL FRONT LOWER BUMPER ABSORBER


    1. A00E918

      Insert the 2 hooks of the front lower bumper absorber into the installation holes on the body to install the front lower bumper absorber.

    2. Install the 8 bolts.

    3. A00E9IN

      Install the 2 clips.