TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A00ORGX

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE AIR CLEANER CAP AND HOSE


    1. A010OJ5

      Detach the clamp and disconnect the mass air flow meter connector.

    2. Disconnect the No. 2 ventilation hose.

    3. Disconnect the air cleaner hose.

    4. Detach the 4 clamps and remove the air cleaner cap.

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A010O7W

      Remove the 3 bolts and air cleaner case.

  4. REMOVE FUEL FILTER SUPPORT

    A007NGZ

    1. Disconnect the connector and detach the 2 wire harness clamps and connector clamp, and then disconnect the engine wire from the fuel filter support.

    2. Remove 2 nuts and disconnect the fuel filter assembly.

    3. A007LQI

      Detach the connector clamp from the fuel filter support.

    4. Remove the 4 bolts and fuel filter support.

  5. REMOVE AIR CLEANER BRACKET

    A007KAJ

    1. Remove the 3 bolts and air cleaner bracket.

  6. REMOVE NO. 2 ENGINE UNDER COVER


    1. A00E945

      Remove the 4 clips and No. 2 engine under cover.

  7. DISCONNECT AIR FUEL RATIO SENSOR CONNECTOR

  8. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the 2 bolts and 2 compression springs.

    2. Disconnect the front exhaust pipe from the 2 exhaust pipe supports.

    3. Remove the gasket.

  9. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR

    A010R5A

    1. Remove the 5 nuts and heat insulator.

  10. REMOVE CONSOLE BOX ASSEMBLY


    1. Remove the console box Click here.

  11. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A010RTWE01

      Disconnect the end of the transmission control cable from the shift lever.

    3. A010PMVE01

      Using a screwdriver, pull out the stopper of the transmission control cable.

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. Rotate the nut of the transmission control cable counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

      Text in Illustration
      *1 Stopper
      *2 Nut

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

    5. A010OSQ

      Remove the nut and disconnect the control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable from the control cable bracket.

    7. A010R2Q

      Remove the bolt and disconnect the transmission control cable support.

    8. A010N3I

      Remove the 2 nuts and disconnect the transmission control cable.

    9. Pull out the transmission control cable.